Skip to main content

voltage division & current division

Current is constant in a series circuit and voltage is constant in parallel circuit.

Voltage Divider :

Voltage division is the result of distributing the input voltage among the components of the divider. A simple example of a voltage divider is two resistors connected in series, with the input voltage applied across the resistor pair and the output voltage emerging from the connection between them.

voltage divider

voltage divider 2

Current Divider :

Current division refers to the splitting of current between the branches of the divider.

current division

 

 
Labels:

Comments

Post a Comment

Popular posts from this blog

Lorentz force equation

  Lorentz Force Equation   The force experienced by current element in magnetic field is given as sum of force due to electric field and magnetic field.   Force due to electric field: A region is said to be characterized by an electric field if a particle of charge q moving with a velocity v experiences a force Fe, independent of v. The force, Fe, is given by              F e = qE ---------------------------------------- (1.1)                    E is the electric field intensity. Measured in newtons per coulomb (N/C) or volts per meter. Where volt is a newton-meter per coulomb. The line integral of E between two points A and B in an electric field region gives voltage between A and B. It is the work per unit charge done by the field in the movement of the charge from A to B. Force due to magnetic field: If a charged particle experiences a force which depends on v, then the region is said to be characterized by a magnetic field. The force, Fm, is given by                     F m =...
2 comments
Read more

relay

A relay is an electrically operated switch. These are remote control electrical switches that are controlled by another switch. A relay is used to isolate one electrical circuit from another. It allows a low current control circuit to make or break an electrically isolated high current circuit path. The basic relay consists of a coil and a set of contacts. The most common relay coil is a length of magnet wire wrapped around a metal core. When voltage is applied to the coil, current passes through the wire and creates a magnetic field. This magnetic field pulls the contacts together and holds them there until the current flow in the coil has stopped. The diagram below shows the parts of a simple relay. Operation: When a current flows through the coil, the resulting magnetic field attracts an armature that is mechanically linked to a moving contact. The movement either makes or breaks a connection with a fixed contact. When the current is switched off, the armature is usually returned by...
1 comment
Read more

P-type semiconductor

The extrinsic  p Type Semiconductor  is formed, when a  trivalent impurity  is added to a pure silicon or germanium atom in small amount and as result large number of holes are created in it. A trivalent impurity like boron, aluminium, nitrogen, gallium, indium. have having three valence electrons but silicon or germanium have four valance electrons. so, it forms only three covalent bonds. In the   fourth covalent bond , only the germanium atom contributes one valence electron, while boron atom has no valence bonds. Hence, the fourth covalent bond is incomplete, having one electron short. This missing electron is known as a  Hole . Thus, each boron atom provides one hole in the germanium crystal. As an extremely small amount of boron impurity has a large number of atoms, therefore, it provides millions of holes in the semiconductor.
Post a Comment
Read more