Skip to main content

Nodal Analysis

The nodal analysis and the mesh analysis are based on the systematic application of Kirchhoff’s laws.


Nodal analysis is a method that provides a general procedure for analyzing circuits using node voltages as the circuit variables. Having ‘n’ nodes there will be ‘n-1’ simultaneous equations to solve.


The procedure for analyzing a circuit with the node Analysis:




  1. Identify all nodes of the circuit.

  2. Select a node as the reference node also called the ground and assign to it a potential of 0 Volts. All other voltages in the circuit are measured with respect to the reference node.


for example in the below circuit nodes are Va,Vb and Vc with respect to reference       node D. nodal1


According to Kirchhoff's current law  we have  I1 + I2 = I3   and  I=V/R from ohm's law.


   so we have  I1 = (Va - Vb)/10 ;   I2 = (Vc - Vb)/20 ;   I3 = (Vb)/40


nodal 2.gif


As Va = 10v and Vc = 20v , Vb can be easily found by:


nodal 3

 
Labels:

Comments

Post a Comment

Popular posts from this blog

Lorentz force equation

  Lorentz Force Equation   The force experienced by current element in magnetic field is given as sum of force due to electric field and magnetic field.   Force due to electric field: A region is said to be characterized by an electric field if a particle of charge q moving with a velocity v experiences a force Fe, independent of v. The force, Fe, is given by              F e = qE ---------------------------------------- (1.1)                    E is the electric field intensity. Measured in newtons per coulomb (N/C) or volts per meter. Where volt is a newton-meter per coulomb. The line integral of E between two points A and B in an electric field region gives voltage between A and B. It is the work per unit charge done by the field in the movement of the charge from A to B. Force due to magnetic field: If a charged particle experiences a force which depends on v, then the region is said to be characterized by a magnetic field. The force, Fm, is given by                     F m =...
2 comments
Read more

relay

A relay is an electrically operated switch. These are remote control electrical switches that are controlled by another switch. A relay is used to isolate one electrical circuit from another. It allows a low current control circuit to make or break an electrically isolated high current circuit path. The basic relay consists of a coil and a set of contacts. The most common relay coil is a length of magnet wire wrapped around a metal core. When voltage is applied to the coil, current passes through the wire and creates a magnetic field. This magnetic field pulls the contacts together and holds them there until the current flow in the coil has stopped. The diagram below shows the parts of a simple relay. Operation: When a current flows through the coil, the resulting magnetic field attracts an armature that is mechanically linked to a moving contact. The movement either makes or breaks a connection with a fixed contact. When the current is switched off, the armature is usually returned by...
1 comment
Read more

P-type semiconductor

The extrinsic  p Type Semiconductor  is formed, when a  trivalent impurity  is added to a pure silicon or germanium atom in small amount and as result large number of holes are created in it. A trivalent impurity like boron, aluminium, nitrogen, gallium, indium. have having three valence electrons but silicon or germanium have four valance electrons. so, it forms only three covalent bonds. In the   fourth covalent bond , only the germanium atom contributes one valence electron, while boron atom has no valence bonds. Hence, the fourth covalent bond is incomplete, having one electron short. This missing electron is known as a  Hole . Thus, each boron atom provides one hole in the germanium crystal. As an extremely small amount of boron impurity has a large number of atoms, therefore, it provides millions of holes in the semiconductor.
Post a Comment
Read more